CRM Error CodesThe CRM error codes are (reasonably) well documented here in the CRM SDK. If you’re searching for the code, one thing to watch for is that the code may be referenced with a prefix of 0x (which indicates the code is represented in hex) – e.g. 0x80040201. If you search for the code, it’s best to remove the 0x prefix.
It is also possible that you may receive the code as an integer (e.g. -2147220991). If you do, convert if to hex (I use the Calculator application), then search for it.Windows Error Codes
There is more variation in how you may identify a Windows error code, but they are ultimately numerical values starting from 1, and (as far as I’m aware) are consistent across versions of Windows. Newer versions of Windows may include error codes that don’t exist in previous versions, but the same error code should have the same meaning across versions.
There is a quick and easy way to get the message associated with a given code – go to a command prompt and enter NET HELPMSGNET HELPMSG 5
And you’ll get the result“Access is denied”
This is the message for error code 5 (which is probably the most common code I encounter, though I don’t keep stats on this…)So, that’s fine if you’ve been given the error code as an integer value (I don’t know what the highest valued error code is – it’s probably either in the high thousands, or maybe 5 digits), but it’s not always that easy.
The code may be in hex(aka hexadecimal). If it contains one of the characters a-f, then it’s in Hex and you’ll need to convert it to decimal. I use the Calculator application to do this. Also, the value may be provided in hex but comes out just as digits. So, if I have an error code, and the message seems entirely irrelevant, I normally convert the code as if it were in hex to decimal, then pass it to NET HELPMSG.The code may be in hex, but supplied as a 32-bit (or maybe 64-bit) integer with some higher bit flags set, for example:
The prefixes 0x and &H are some ways to indicate the value is in hex, and these prefixes can be discarded. You can also discard all but the last 4 characters (in these examples 0005, 0002 and 0035) and convert them from hex to decimal (in these examples giving 5, 2 and 53 respectively).
Finally, you may get a 32-bit integer with some higher bit flags set, receive the value in decimal, rather than hex. These almost always have the highest bit of a 32-bit value set, which means that in decimal they come out around 2 147 000 000 (or more commonly as a negative number, as they are typically signed integers). So, if I got an error code of -2147024891, I would:
- Convert it to hex, giving 80070005
- Discard all but the last 4 characters, giving 0005
- Convert it back to decimal, giving 5
- Run NET HELPMSG 5, and find that I’ve got another ‘Access is denied’ message